[SSJ3_Vegeta]

I bet nobody expected to see me back here

Long story short, the old desktop computer at my house finally broke down and I went without a computer for quite a while. Fortunately the hard drive was unharmed, so now that I have a new computer and plenty of free time, I've been working on my old projects again. But since I installed the HD on my new computer, Zmodeler hasn't been able to load textures. The only one that works is the texture for my tire tread and sidewall. Otherwise, they won't show up. I also can't load pictures into the editing views. All my 3d views look like this



Obviously I made sure that the Show Textures box was checked (it is), and I've un- and re-installed the software several times. I know it's not the computer, my old roommate has the exact same computer and it runs the program just fine. I have no idea what would cause this. Perhaps someone here does? Any help would be greatly appreciated, as I could start finishing all my damn cars

[ediblechickenwing]

I assume you've reassigned the textures? It probably can't find them anymore if the path to them is different.

[Dudes__Geof_]

Hoooolllllllllly crap! Blast from the past.

Looks really good Veggietales... I haven't touched zmod in at least a year so I don't even remember how to assign textures...
_________________

[b12man]

Might be able to fix it by pressing E to open the material editor, then selecting each material and re-loading the texture it uses
_________________


Tutorials || Make Your Own Traffic | Change Traffic Tuning
Projects || 93 Mustang GT | 85 Chevy Suburban [WIP]

[SSJ3_Vegeta]

You would think so, but I've tried reassigning and remapping every material multiple times with no luck :/ All the texture paths are correct and everything, and for some reason the tire textures still work, but nothing else does.

[Silent1Unknown]

Hey, welcome back! I remember some of your projects. Good to hear youre finishing some stuff up.

For the textures problem, also check in Material Editor that each texture has all the right settings (i.e. "Type" is set to Unused or Glowing and under the "Textures" section, right after "Primary Texture", "Apply As" is set to Mix with color).

See if that helps.
_________________
2010 MM2C AWARDS
Most Helpful to the Community Award
Mr. Nice Guy Award
Helping Hand Award

[Jason]

Whoa.
Hey Sam, you still around this neck of the woods?
Sweet looking model man. I'd help you with your problem but I don't use ZM lol.
_________________