Some ppl here probably know about this, but it might be interesting anyway: (note: Im not very good at describing things... )
Step 1:
here I have a very hastily made well (not 3d)
Step 2:
go to Display>Place Axis
in front view, put the axis a little bit to the side:
Step 3:
go to Create>faces>fan, and create a half circle that has as many points as ur wheel well:
Step 4:
go to Creat>faces>strip and connect the fan with the well.
Step 5:
Go to Modify>Move and move the fan points under the well and voila ur done!:
_________________
Nice tutorial! I use a very similar method, but to save some polys I make the 'back' of it as a flat surface.
Uses less polys and noone will notice any difference anyway.
To expand on Charger's:
Note the fact that the curve polys connect to both sides of the car, thus meaning you don't need seperate polys for the left/right sides. The polys are all set up the same, spanning the entire width of the car on the underside, and its 3 sides of a box in the middle. _________________
Hi!
I can bend minds with my spoon.
A member of Team Graduation 2004/05!
25 Jan 2003 06:24 pm
Midtown_Master VERY MUCH need to worry
Joined: 22 Jul 2002
Posts: 808
Status: Offline
Post subject:
Very interesting Stereo, i never thought of that! _________________
Hmm.. You guys have it down packed better than I do.
Mind if I show something along the lines of that on my tutorial? _________________
25 Jan 2003 08:02 pm
Midtown_Master VERY MUCH need to worry
Joined: 22 Jul 2002
Posts: 808
Status: Offline
Post subject:
Awesys wrote:
Hmm.. You guys have it down packed better than I do.
Mind if I show something along the lines of that on my tutorial?
Its fine with me _________________
26 Jan 2003 12:54 am
Page 1 of 1
All times are GMT
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum